First turn off the instrument and turn off the water supply tap at the water inlet valve.
Remove the reverse osmosis membrane shells at both ends of the fast-plugging water pipes – water pipes, water pipes, waste water pipes, pull out the attention of these three water pipes to distinguish, to prevent the installation of the wrong position, if it can not distinguish, The proposed marked with the corresponding mark can be identified in order to avoid mistakes. And then pull up the base shell card force upward bayonet;
Face equipment, with his left hand to tighten the reverse osmosis membrane shell, with the right hand forced open the reverse osmosis membrane cover.
With the left hand to tighten the reverse osmosis membrane shell, and then clamp the old reverse osmosis membrane pliers, its force pulled out.
The new reverse osmosis membrane stuffed into the tube until there are two small black “O” ring to the bottom of the end of the shell until the shell and then tighten the shell cover.
Place the membrane shell in the direction of the original placement into the base mount, and then insert the corresponding water pipe into the quick-connect connector and the blue clip on the card.
Open the original tap at the water inlet valve, start the ultra-pure water machine to observe whether there is leakage in the cleaning state, if not then the replacement is completed.
Remind: In the replacement of reverse osmosis membrane pay attention to the inlet, outlet, waste outlet (Hangzhou library Hong company equipment in the factory before the corresponding ports are labeled with the corresponding label), shell only one end of the mouth for the inlet , The other end of the tube a little longer for the outlet, the mouth is slightly shorter for the wastewater discharge. In addition, users must pay attention to the direction of the reverse osmosis membrane into the membrane shell.
