In the process of manufacturing the bag filter, its process-leading product structure and function design, the compact structure of the entire device and the unique overall shaping and processing technology of the filter shell, which will effectively avoid the steel to some extent All kinds of dripping caused by the filter shell welding, high-strength ductile iron materials have excellent anti-corrosion properties, extending the product’s service life.
The bag filter uses its proprietary filter cartridge design and manufacturing technology. Its high-precision filter cartridge never wears out. When it is in use, the pressure test will never be deformed. The factory precision test meets the user’s requirements, and the coarse and fine filters are The stainless steel welded mesh, sieve plate and screen form an internal and external double-layer structure; since the active cleaning method is adopted for the filter element, the anti-interference ability is enhanced, and the cleaning is thorough, which is particularly suitable for poor water quality conditions. The
The bag filter waits until its treated water enters its equipment rate from the inlet. When it is used, the impurities in the water will deposit on the stainless steel filter. This will cause a pressure difference, which will be effective when used. Through its pressure switch to monitor the differential pressure at the inlet and outlet, when the pressure difference reaches the set value, the electronic controller to the hydraulic control valve, drive motor signal, trigger the following actions: the motor drives the brush to rotate, the filter cartridge is cleaned, and the control valve Open the sewage, the entire cleaning process lasts only tens of seconds, when the cleaning is completed, close the control valve, the motor stops rotating, the system returns to its initial state, and begins to enter the next filtration process.
After the bag filter is installed, the technicians perform debugging and set the filter time and cleaning conversion time. The water to be treated enters the body from the water inlet, and the filter starts normal work. When the preset cleaning time is reached, the electric controller To the hydraulic control valve and drive motor signal, the following actions are triggered: the motor drives the brush to rotate, the filter element is cleaned, and the control valve is opened to discharge the dirt. The entire cleaning process lasts only several tens of seconds. When the cleaning is completed, the control valve is closed. The motor stops rotating and the system returns to its initial state and begins the next filtration process.