The bag filter needs to go through its equipment when filtering its high-concentration waste water. The high-concentration waste water to be treated in the bag filter is directly from the water inlet to the rate of its equipment, and its bag filter Impurities in the water deposit on the stainless steel filter, which creates a pressure difference.
The bag filter will, to some extent, monitor the pressure difference between its inlet and outlet through its pressure difference switch. When the pressure difference reaches its set value, the electronic control water supply control valve and the drive motor signal trigger the following actions: The motor drives the brush to rotate, the filter element is cleaned, and the control valve is opened to discharge the dirt. The entire cleaning process lasts for several tens of seconds. When the cleaning is completed, the control valve is closed, the motor stops rotating, and the system returns to its initial state and starts to enter. The next filtration process.
After the bag filter is installed, its technicians will effectively carry out its debugging, the device set the filtering time and cleaning conversion time, and other processing water from the water inlet into the body, the bag filter starts normal work, when When the preset cleaning time is reached, the electronic controller gives the hydraulic control valve and the drive motor signal, causing the following actions: the motor drives the brush to rotate, the filter element is cleaned, and the control valve is opened to discharge the dirt. The entire cleaning process lasts only tens of seconds. .
The mouth of the filter bag was damaged more than 30-40 cm below the mouth of the bag, and the bottom layer of the filter was blown and peeled. Mostly caused by excessively high compressed air, deflection of the blowing pipe, and deformation of the board. Pay attention to the quality of the installation during the installation.