1: The pulse duster operates with low energy consumption. Because the injection pressure is greatly reduced, and the cleaning method adopts the constant pressure difference control method, the power consumption of the cleaning dust is greatly reduced, and due to the complete cleaning, the surface of the filter bag is thin and gray, so the equipment resistance is lower than that of the counter-blow bag. Precipitator, so the system main motor power can be reduced by about 20%;
2: The pulse dust remover has a large working capacity, and the device itself is equipped with a pulse cleaning system, and it does not have to work hard for large air volume.
3: The performance of the pulse dust collector is reliable. The pulse controller is used. The circuit is simple and the work from the first time to the second time is adjustable.
4: The pulse dust collector box adopts A3 steel, cylindrical design box body, its strength is good, the failure rate is low, and installation and debugging are extremely convenient.
5: The filter bag of the pulse dust collector can generally reach 6-8 meters, about 3-4 times longer than the traditional filter bag, so it occupies a very small area and investment is saved. Due to the long filter bag and high filtration load, the filter area needed to process the same flue gas is less than that of the counter-blow air bag filter, so the device has a compact structure, less steel consumption, and lower equipment cost.
6: The pulse dust collector has a small footprint, almost no noise, and a unique design
7: It is convenient to check and replace the filter bag with pulse dust collector. When the counter-blow bag filter is replaced, the operator needs to enter the interior of the box to bind the filter bag and the operating environment is very poor. The installation of long-bag low-pressure fast pulse bag filter bag is based on the elastic ring of the bag mouth to embed the filter bag on the flower plate without tie-up or bolts. When the bag is replaced, the person is on the net side of the flower board, and it is in short contact with the dust bag. The replacement of the bag is very simple, eliminating the heavy labor and improving the operating environment of the bag change.
8: The pulse pressure of the pulse dust collector is low. Due to the adoption of a straight-through rapid pulse valve, the device has quick opening and closing and small resistance. Therefore, for such a long filter bag, the injection pressure is only 0.15-0.25 MPa, and a good cleaning effect can be obtained.
9: The pulse dust remover has a strong cleaning ability. The dust removal capacity of the filter bag is measured by the gravity acceleration g. When using the reverse blow cleaning, the dust removal intensity is usually 35g, and the low-pressure pulse injection method can make the filter bag cleaning intensity reach 60 – 200g. It can be seen that the low-pressure pulse cleaning strength is dozens of times that of the counter-blowing;
10: The pulse dust remover is like a sanitation worker, and it can filter very well. Due to the strong ash protection, even if the dust collector operates at a higher filtration speed, its resistance will not exceed the limit. When used in the same occasion, the filtration wind speed of the low-pressure fast pulse bag filter is usually higher than that of the counter-blow bag filter, so the equivalent filtration area and the low-pressure fast pulse bag filter have a larger processing air volume;
11: The pulse dust remover has a small maintenance workload. Due to the large dust removal area borne by the pulse valve, the number of pulse valves is greatly reduced compared with the traditional pulse bag filter, and the quality of the diaphragm and the reduction of the injection pressure make the service life of the pulse valve diaphragm significantly improved. Reduced workload
According to statistics, the effect of dust collection on pulsed dust collectors has reached 99%. In fact, its greatest advantage is that it can satisfy all kinds of mining equipment and can run smoothly in harsh environments.